Search results

I want to practice programming this controller. The instruction manual indicates that the temperature probe should be connected before turning the unit on. I don't have a spare probe. Would be nice if I could provide power to the unit and turn it on and practice in my office. My electric panel...

I'm building an Electric Panel to fire 4 Electic 5500 watt heat elements simultaneously. Thinking of powering the 240 volt panel using two 50 or 60 amp span gfci panels. Or If I use just one 100 amp panel how would I obtain the gfci ? Span gfci panels seem to be available up to 60 amps.

Has anyone used an Auber SYL-2381 temp controller with RS-485 to run an SSR for a heating element in a kettle and interfaced it with there computer ? Just reading about it on the Auber Instrument Web Site.

I'm building a 60 amp brew panel with a 60 amp gfci. Not sure why but almost all of the electric panel builds discussed stop at 50 amps. I will have 2-5500 watt heat elements. And the extra 10 amps or more gives me power for a rims tube smaller element. I need to observe a 60 amp panel build...

When a kettle is fitted with 2 or more electric elements are they usually controlled with one or two or more controllers ? I'm familiar with pid and power regulators. Just thinking about adding another 5500 watt element heater to a 30 gal kettle.

I have a Spike CF15 Conical. Not sure if the accessory racking arm is needed. Does it turn all the way down to the 6o'clock position to pull the wort off below the port connection ? It looks like it may only turn 1/2 way not all the way around. If it does turn all the way around & down then it...

I want to upgrade & add some automation to my 50amp 2 element rims system. I was thinking of using Solo PID's from Automation Direct. Thses PID's can tie into a RS-485 port and they can be programmed and monitored using a computer. Evidently I want my electric 240 volt system have a graphics...