Search results

Please count me in, Thanks.

You guys are correct, it is difficult to recirculate without a little heat the pump and lines cool the wort off some, depending on the outside temp. I have found adding heat to the system is easier with the lower output, small burner. iF you want to step up the temps you have a couple of...

Not sure on total price, but I think just the stainless was around 850 to 900. As for the pots the big Pot is 18 ish wide and it fits fine. Not sure how big kegs are I think it would fit ok. Just draw it out on a big piece of cardboard and set your pots on it. That is my second build and yes...

Here are some more shots I put a tape measure on to give some idea of scale.

I took a few pics for you to look at. The 15 and 20 gal pots just seal the middle area up too much. The grate is 5/8 solid bar stainless 304 I think, I put two down feet in the small triangles so it does not move around. It is very stable.

I had a similar problem with my stand build, I solved the problem by making grates for the pots to sit on. There are several videos on U tube showing the flame problems. The gas tends to collect in the top and spills out around the bottom and the flame is spilling up the side. Have fun with the...

I had the same problem with the burners, my pots sealed the inside diamond and it causes a flame problem. There are several u tube videos of this problem. I made grates to set the pots on and it works fine and the pots are stable. Good luck and have fun building

Please count me in!

I am interested in these but I can't get down to your area until Monday eve. If someone else is able to get to you prior that's ok. If that is ok PM me w your info, thanks Sent from my iPad using Home Brew

Count me in too, I agree just the push I needed to join. Thanks to all the sponsors!!

My buddy that got me hooked on brewin introduced me to the site. I was a lurker for about a year and decided to join in the fray. Sent from my iPad using Home Brew

I built a similar size unit and the bottom is not flat. It had four feet formed into it near the corners. I found some small three wheeled furniture Dolly's at the local Menards. I set them on it and secured then on the bottom of the feet with short self taping screws. The wheels are kind of...