Search results

Great job. Are you going to move to a BCS system at some point?

Thanks. In the youtube video you have (page 7) it looked like there was a false bottom in the HLT, which seemed a bit excessive, but also made me wonder if you were using them in all 3. Thanks again.

Do you use false bottoms in all three of your brew pots?

I tried the valve today and it works. So, that should give you a little more confidence.

Updated drawing that actually works. Thank you tphjr!

You are my hero!

I'm sorry I'm not following you. So for instance connect the Green wire from the valve into NO4, but where do the Red and Black wires go?

My wiring is like the image attached.

This is just for liquids, not for gas. I did try and place the Black into the GND and the red and green into the VDD side (not at the same time). The ball valve does start moving (open for green and close for red). I had thought that the voltages on the output side of the relay would be in...

So I'm having some difficulty with my valves and relay board. I bought a 8 relay module board 12V see ebay: http://www.ebay.com/itm/250609010929?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649 And I have some 12V ball valves: http://www.tf-valvefittings.com/goods-2.html I have a 12V 2A...

I bought from them. Prices/shipping were reasonable and the whole process only took a couple weeks. I haven't tried out the valves yet, but having a paypal option was a big plus for me.

I made up a drawing, but I'm no EE. Is this the valve and wiring you used? A KLD 1/2" Stainless Steel 12VDC, KLD20SB3Z12.