Search results

I just bought the Malt Muncher 3 and was planning to just use my drill, but then yesterday I was tossing out an old Rigid table saw and salvaged the motor before I did. I was doing some research about using a salvaged motor, but I'm stuck on what pulleys/sheaves I'll need etc to bring this whole...

I'm currently building a glycol chiller from an 8000BTU AC that I'll use to control two 14gallon Chronicals. My brewing location in the garage is currently far away from a water source :rolleyes: I was thinking of adding additional ports to my glycol chiller so that I could hook up my...

I have a 3 keggle system and I'm looking to add a Stainless Brewing Herms coil. Any suggestions on the 25' vs 50' coils? I'm leaning towards the 25' coil because I think I'll be able to utilize a plugged off bulkhead. If I go with 50', I'll more than likely have to drill two new holes. My other...

I've decided to go ahead with the STC1000 to set up my fermentation chamber. The wiring diagram is basic so that is no problem. I watched a video where a guy set up the hot and cold side each with a female power cord and of course the power with a male. Where do I get the female/male cords...

So here is what I'm thinking for my next brew: 9# Pale Malt 1# Oats, Flaked 1# Chocolate 1# Crystal 120 1.5oz East Kent @ 60min WL1084 I'm planning to also add vanilla beans and cocoa powder but haven't settled on the timing. Also considering adding lactose (1/2pound?) to really get that...

I get my brew water from Eldorado Springs. This is the basic water analysis information from their website: http://www.eldoradosprings.com/?action=analysis pH 7.22 Chloride 1.1 mg/L Sulfate 21 Bicarbonate 40 Calcium 12.4 Magnesium 3.85 Potassium 2.64 Sodium 6.4 From my research...

http://www.northernbrewer.com/shop/northern-brewer-rye-malt-syrup.html How much of this syrup would I need to make a 1.100 OG 5 gallon batch?