Search results

The prices I have seen have been like $50 for 25ft which seems pretty steep for bulk wire. Has anyone found a place that sells 10/3 wire rated for outdoor use?

I am still in the R&D phase of an E-HERMS build and was wondering about the viability of using my current Mash tun with some minor modifications. My biggest concern is the manifold I use. I have a Coleman extreme 70qt cooler with a copper manifold going into a bulkhead. The manifold is...

SOLD Someone got this for me as a present and I can't use it, so you can have a brand new, never used Hopblocker shipped to your door for cheaper than what I have seen around. $55 Shipped to the continental US

I have a gallon starter going right now of Wyeast 1762 Abbey II. I would like to save some but now the yeast will be pretty well shot after fermentation. What is the best way to save a portion of a starter? I have a bunch of half pint jars that I use for washing. Should I pour a portion into a...

So I am doing a Belgian Dark Strong Ale. Fermentation started off well, had to put a blow off tube on, life was good. I missed my target when mashing, so I added some DME, started moving again, things were good. I made one last sugar addition, both for points and to dry it out. It's been 19...

Bink Grand Cru and 2009 Cellar Reserve Sheep Eater Scotch Ale I don't know anything about either one, but last months was fantastic so I am pretty excited for these two. Is anyone else a member? I got it as a Christmas present, and it is a little pricey, almost $50 a month for 2 bottles...

I did my third all-grain batch this past weekend and it was about 20 degrees outside. I could not hold temps in my mash at all. I use a Coleman Xtreme cooler, which I know can hold temps, but I guess it was just too cold outside. Has anyone else run into this problem? I am guessing that...

So I was doing my first all grain batch, which didn't go well but that is another story, and at the end day, consumed with frustration, I did something so completely stupid. I left the grain in the mash tun. For a long time. When I opened it I almost lost it. It was something I had never...

So my first beer has finally had enough time (3 wks) in bottles that I can taste it without worrying too much about it being green. I cracked one open last night, had a nice puff of co2 smoke sitting in the bottle. When I poured, it developed a lot of head and spilled over the glass, not sure...

I was wondering if anyone could point me in the right direction for a relay that could switch on a 120v AC supply with a 5v DC control. I wired up the monitoring side of a temp controller with my Arduino and three DS18S20 nics, so now I want to get the other side working. The Arduino has a 5v...

I tested my CFC I built tonight and unfortunately it has a few leaks at one or two joints. I already blew through a copper t-fitting in my quest for knowledge and experience with soldering copper. Is it safe to heat the joint again and re-apply solder or should I look at something like JB-Weld...