Search results

Long story short this is a cart mounted all electric automated recirculating mash setup. There is a control panel just like brewkart has on the RH side you can't really see. Everything is hard plumbed and it only uses one pump, requires no pulling or reconnecting of any lines. It is very...

I did do some searching and couldn't find an answer... although I'm sure it is out there hiding! So if I'm missing it and you know where it is, please post the link. I'd like to add a 2nd RTD sensor to my system into Mash Tun. I already have one in my Boil Kettle and have a Auber PID...

Can some people with experience please way in on whether or not it is better to use K type or RTD temp probes with your arduino? And how you wired yours up and how it works would be appreciated too. Thanks. I'm planning on buying one of the above types from Auber, but can't decide which is...

Has anyone attempted to use a stir plate with stir rod in their boil kettle? Obviously this would pertain to electric setups, not gas setups. Just curious how the results were, or if there were any issues. There are stir rods and plates rated up to 600 liters on the market, so it seems feasible.

Kind of a newb question, but I was wondering if it would be possible to put all of my grain into a painters bag. Drop that bag into my mash tun. It should be large and pliable enough to fill out the bottom of the tun. Obviously the false bottom would still be there. The whole point would be...

Wanted a cheap and easy way to wash my bottles and my carboys. This setup can wash 1 carboy, 5 bottles, or 10 bottles based upon which valves are turned. Pump is a Barracuda and can output about 1500 gph. Cost came in just under $60 NOT including the container. The nice thing is that for...