Jester4176
Well-Known Member
ok...Have my regulator setup all hooked up, but having a small problem with it. Here's a pic of it:
Ok, I'm working with what I have here because funds are limited for new parts. So, I have a full 4 port reg, and a 3 port secondary reg. Since I'm wanting to run 4 kegs off of it, I set it up as such. Each output has a T fitting before branching off to each keg. The first reg is set at ~24 psi and runs a keg of root beer and cream soda.
The secondary reg will run 2 kegs of beer that I'll be kegging later this week. One problem though....The psi on the secondary reg keeps rising up. As you can see in the pic, the secondary is pegged at ~45psi, but the screw is backed all the way out, so it should be letting NO air through. Should that reg be rebuilt? Or is it something else that is causing this problem? I'd like to get this fixed before kegging my 2 beers.
Ok, I'm working with what I have here because funds are limited for new parts. So, I have a full 4 port reg, and a 3 port secondary reg. Since I'm wanting to run 4 kegs off of it, I set it up as such. Each output has a T fitting before branching off to each keg. The first reg is set at ~24 psi and runs a keg of root beer and cream soda.
The secondary reg will run 2 kegs of beer that I'll be kegging later this week. One problem though....The psi on the secondary reg keeps rising up. As you can see in the pic, the secondary is pegged at ~45psi, but the screw is backed all the way out, so it should be letting NO air through. Should that reg be rebuilt? Or is it something else that is causing this problem? I'd like to get this fixed before kegging my 2 beers.