So I had a stout kegged using a dual valve regulator that has 2 separate valves for each keg, was working great at 8 - 9 psi... I had to take it off CO2 for a few days while I replaced a valve on the 2nd "connection". I didnt touch the "connection" that was hooked to the carbed stout keg. I applied pressure again 3 days after I turned off all pressure. Psi was sitting around 16 now... I turned it down (turned the "screw" counter clockwise) to the point it was almost out of the regulator... I just turned it back up to see if I could gain pressure just to be sure it was working correctly... anything else I should try?
thanks
thanks