blacksquid
Well-Known Member
**EDIT: OOPS. Sorry this should be in DIY Projects! Could a mod please move this?**
95% done, I cut some thick plastic to go over it and need to get some more machine screws and wing nuts to keep it in place. Then, drill some holes in the plastic for the mounting screws on my B3-23A-30 plates duda chiller to go through.
The original idea was to mount it the other way around (bottom up), but I scrapped the idea of using the holes to install a handle, when I already have two of them already on it. Seeing as the PC would sit on it, the balance was also a bit weird. The PC sits perfectly on the sides of the bin.
I may cut the plastic to add a hinge but I don't plan on having to look at the wiring all that often. I'll post pictures when I'm done with this - the fittings from Duda should be here anytime now.
95% done, I cut some thick plastic to go over it and need to get some more machine screws and wing nuts to keep it in place. Then, drill some holes in the plastic for the mounting screws on my B3-23A-30 plates duda chiller to go through.
The original idea was to mount it the other way around (bottom up), but I scrapped the idea of using the holes to install a handle, when I already have two of them already on it. Seeing as the PC would sit on it, the balance was also a bit weird. The PC sits perfectly on the sides of the bin.
I may cut the plastic to add a hinge but I don't plan on having to look at the wiring all that often. I'll post pictures when I'm done with this - the fittings from Duda should be here anytime now.
