msexton
Active Member
OK, I just bought a couple new Chugger replacement heads with the center inlet. Apparently, this is 3/4 inch MPT. All of my hoses have 1/2 camlocks. Does anyone have any suggestions for the best way to set this up?
Can I get a male camlock with 3/4 FPT that will connect to my 1/2 camlock hoses or would I need a 3/4 FPT to 1/2 FPT (or MPT) reducer? If I need a reducer, does anyone know where I could get one in stainless?
Thanks,
Mike
Can I get a male camlock with 3/4 FPT that will connect to my 1/2 camlock hoses or would I need a 3/4 FPT to 1/2 FPT (or MPT) reducer? If I need a reducer, does anyone know where I could get one in stainless?
Thanks,
Mike