StunnedMonkey
Well-Known Member
So SWMBO gave approval for a new kegerator, and I had the 8.9 cu ft Whirlpool Chest Freezer in the house within an hour. Minds can change, so one must act fast. Two questions...
I'm going to use this template for the collar:
Chest Freezer Collar
So there will be an inner 2x4 and an outer 1x6. That means three inches of collar to drill through for the shanks. What length shanks shoud I get to make sure they're long enough to attach the faucets (Perlicks) and beer lines, without leaving too much length that they''ll be in the way?
As far as attaching the beet line to the shank, is this the connector that I need?:
Connectors for Beer Lines Replacement Parts - Beer & Air Line
If not that, then what?
So I need the faucet, the shank, the beer line connector for shank, the beer line (3/16), and the disconnect for the corny. Is that it as far as the corny to faucet connection? Anything I'm missing?
I'm going to use this template for the collar:
Chest Freezer Collar
So there will be an inner 2x4 and an outer 1x6. That means three inches of collar to drill through for the shanks. What length shanks shoud I get to make sure they're long enough to attach the faucets (Perlicks) and beer lines, without leaving too much length that they''ll be in the way?
As far as attaching the beet line to the shank, is this the connector that I need?:
Connectors for Beer Lines Replacement Parts - Beer & Air Line
If not that, then what?
So I need the faucet, the shank, the beer line connector for shank, the beer line (3/16), and the disconnect for the corny. Is that it as far as the corny to faucet connection? Anything I'm missing?