Brutus 10 Asco Alternative

What is a good alternative, I found the one from Lonnie Macs plans but its up to 400 a peice now, would this work? http://www.ebay.com/itm/1-2-NPT-ELE...854&pid=100015&prg=1006&rk=3&sd=360511342502&

I have the same question. They are expensive valves. Did you ever get an answer?

Cheers,

Duane

I think some guys have used these. I can't remember if it was for the Brutus or something similar.
http://www.ebay.com/itm/290716195361?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1438.l2649

Thanks for confirming what I thought. I saw a thread where they mentioned the part you posted.

Cheers mate

I did a standing pilot valve, I only have one since I am running a Brutus 2.0 but it is the same concept and it will only cost about $100 per automated burner. You have a safety measure built in with the pilot system, if the thermocouple on the pilot isn't lit it will not open the valve. I am running low pressure propane, and if you want to run high pressure the ones previously mentioned would probably work. My build is in my signature.

HTH,
-G

limulus said:

I think some guys have used these. I can't remember if it was for the Brutus or something similar.
http://www.ebay.com/itm/290716195361?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1438.l2649

Click to expand...

I've used these valves on my stand and they work well. But no safety mechanism as mentioned previously.