Recent content by zeg

Also, unless you need to free up the primary fermenter, I'd just leave the beer alone for the entire 3 weeks. Under ordinary conditions, there's little reason to move a beer to secondary. For standard mid-gravity beers, I don't bother much with FG readings if the fermentation was "normal." I...

Yes. Just about perfect.

Many of my brews (perhaps most) have a sharp hop-bittery aftertaste. It always worries me, but never shows in the end product. I wouldn't worry. Not much you could do anyway...

I just cut the bag all the way across, open it wide, and dump it as fast as possible. It feels like a lot sticks behind, but it's not really all that much. I prefer this to getting gunk on other implements in the kitchen.

If your bottles are clean, I think it ought to work in principle, but I think it's probably not a terrific idea. Whatever method you use to sanitize, if long as you seal the container, nothing is going to find its way in. Sanitized foil tightly on top is probably good enough for this purpose. It...

Wow, you're edgy. Not sure I can tell where you're serious and where you're ironic, but you're right that you have to choose your battles. However, that's different from advocating poor practices when better alternatives are no more difficult.

...or an 11g pack of dry yeast... :ban:

Yeah, it's the beer you're making. I usually make my starters a bit less than 1.040, based on some book---perhaps Yeast. IIRC, I've seen recommendations from reputable sources that vary from about 1.020 to 1.040 as ideal. I think the key is to create a gentle environment that coddles the average...

No problem being a noob. Don't worry about lager malt, it is just a lightly kilned base malt. You can use pilsener or plain 2-row malt. I've never personally encountered something called "lager malt" at any shop.

You do realize that your method is essentially identical to running one set of numbers on MrMalty, then using that solution for every beer, right? I think pitching an appropriate amount of dry yeast is probably the best approach for inexperienced brewers. I've only ever used 11g packs, so I...

By the way, the BB manufacturer has an extensive write-up regarding cleaning practices. Key recommendations: Do not use excessively hot water, 125°F is sufficient Strong caustics will damage PET, so if you are going to use them, minimize contact time Mixing PBW/OxiClean powder with water...

Well, I gave it another thorough wash with Seventh Gen enzyme detergent (as recommended by BB themselves) on the theory that a different cleaning method might work differently with whatever is causing the streaks. It may have helped a little, certainly the streaks were less prominent, but that...

That .0018 typo should be fixed, it will be seriously confusing to someone not already familiar with this material. (I'd also suggest using leading zeros---writing 0.018 instead of .018---but that's more a matter of style.)

That .0018 typo should be fixed, it will be seriously confusing to someone not already familiar with this material. (I'd also suggest using leading zeros---writing 0.018 instead of .018---but that's more a matter of style.)

I hadn't heard of the rag+oxi thing until a few days ago. I tried it, and it did a great job removing a ring around the shoulder from a batch that had been all but abandoned in the closet since april or so. Sadly, the aging did not make this a good beer: it apparently had a wild yeast problem...