Recent content by zbiggestdaddy

I'll take the pump please. Matt

Would be nice I am in Madison but don't think I have the time to drive there this weekend.

I would buy some off you I am in Madison if you decide to buy the lot.

PM sent on the bulkhead fittings. Thanks,

I bought 50' at closing HD for 24 and made two counterflowing IC which work great. Thought it would be more effiecent than a long 50' coil. The water coming out never got super hot when it was used

Oh and that copper tubing is 60% off so the 50' coil I bought was only 24 bucks the 1/2" OD was 32 I think

Thanks everyone I am going to make two 25' chillers and run them opposite one starting on the top and the other from the bottom up. I got a tee and some tubing. Hope it will all work.

Thanks I hope I am going to be statified I have 50' but I wanted to solder the fitting but can't find the little elbows.

good I just should have used 3/" ID that is what all the chillers are at least right?

I bought copper from a HD going out of business but I found out it is 3/8" OD not ID will this still work from a immersion chiller I have 50' of it and hope it will work please help me out with advise. I really want to get into all grain.