Recent content by yveei

I know this is digging up an old old thread, but how did this work out for you in the end @Corbeermite ?

Good to know, but I'm so sure I had the terminals good and tight. The terminal is loose in the pic by the way, where I tried (unsuccessfully) to remove the connection after the burn. I will indeed brew on though :yes:

Just pitched some Munich Classic today for a wheat beer, so I can let you know in a week or two!

Thanks for this! If it's true then it's a game changer!

So I didn't heed the advice I'd read online about knock off SSRs and decided to buy a Fotek SSR for my electric setup. And on the second use I smelt an odd smell and thought I saw a wisp of smoke. Sure enough when I took my controller apart, there was my SSR... Also to note: this was rated...

Maybe I wasn't putting enough pressure on. I'd lost two bits the night before so I was hesitant to apply too much pressure this time round. Or maybe your drill bit is just a lot better than mine! Try as I might, I couldn't get that pilot hole done any faster than about 5 - 10 minutes. Did you...

This is to thank members of the forum and to help others out... I've been struggling over the past few days to drill a pilot hole into my 70L stainless steel pot. I've watched YouTube videos, read many posts on this forum, and done a lot of Googling. 3 broken drill bits later, here is (IMO)...