Recent content by Ymmot04

Finally finished setting everything up. I took a couple steps backwards after I realized I was going crazy looking at the nasty walls. I had to clear the place out to do some drywall patching, gave the place a new paint job, and put in some trim. Here it is, all finished up.

No sir, I did not. I guess the main concern would be back drafting the water heater or furnace exhaust? If needed I could temporarily crack the window in the bath room next door which is in it's own window well, so it should be separated enough from the exhaust. It shares a wall with the "cook...

I've got an Avantco IC3500, which is a 3500W unit. I went with a vortex blower as well, but a couple steps down = P My 600 series should be delivered tomorrow. At 347 CFM I was thinking it would be overkill. Planning to splice it into the ducting just above the slop sink so I can run a...

Hey all! I'm just getting started, actually haven't done a brew on my own yet, but excited to do the inaugural brew on my first setup. After watching a friend I had a good idea of improvements I wanted to make when I did my build. Here are some pictures of where I'm at so far. It's a 7.5 gallon...