Recent content by wolfpackguy

this. is. awesome! :-) great job

Thanks everyone!

Hey guys, I was offered two "keg" looking things from work. They were only used once or twice, and I know what substances they were used for - and they would be fine for beer contact with cleaning/sanitization. They are in practically new condition. Basically just a little dust. My...

Welcome from Raleigh. From Greenville myself. Go Pirates! (Except when they're playing NC State. =) )

hmmm....at that price i think i'll probably pass. Wonder why his is so much higher....

I found a 9 gallon brew kettle/propane burner on craigslist im thinking of buying this weekend for $90. He says it's aluminum. Anyone ever seen one like this? (see attachments) I've never seen a kettle with a wider mouth like that....and don't know if there's any design flaw that might...

If you like cars, humor, and good old fashioned sexism its.great. The older episodes are a little better tho.

Top Gear. Best show on tv. And the BBC version. Not the lame American knock off.

Off topic, just browsing. Love the avatar!! Lol. Ok. Back to beer.

I used cpvc, which is what most on the forum have recommended. I think its also called 'schedule 80', and is used for most potable water applications and is for high heat. I suppose there may be a chance for off flavors, but I haven't read of many. Copper probably avoids off flavors, but I'd...

Thanks. I kind of thought about that when I did my water run, but by that time I was fed up with the hacksaw and tape measure. I'm sure I will do some tweaking. I saw an example that had a middle cross-pipe, and I'm thinking of bringing the drain off a T from that cross pipe. I think I just...

I drilled through the top, but I did three holes for each interval. Figure a few more holes couldn't hurt.

Got a little side tracked with this, but finally finished my manifold today. Used 1/2" cpvc and 3/32" drilled holes. Turned out ok. Defintely a learning experience. No leaks anywhere. Max flow rate out was about 0.5 gal/min, so hopefully I don't need more than that. I was kinda bummed...

Oops. Here it is. Will add the manifold pictures when I get it done.

Just finished my diy 48qt cooler mash tun. Well, almost finished, just have to get the manifold cut and put in. Thanks to all the forums on here that offered the direction!