I may be looking to sell my three 20 gallon Blichmann Boilermakers (G1) based the Kal's setup. Let me know if you are still looking and I will send you some pictures.
The switch is a 3 Terminal SPST 2 Position Rocker Switch: https://www.amazon.com/gp/product/B071KTQ2F5/ref=oh_aui_detailpage_o01_s00?ie=UTF8&psc=1
The wire splicers came from my tool box in the basement, no doubt left over from a brief car audio hobby back in the day. You could use any wire...
I just finished up installing an aux switch in place of the alarm output.
I started by unplugging the following pins from the control board:
Hot + (black wire) removed from TP7 on the board, this gets attached to PIN 2 on a SPST switch.
Neutral - (white wire) removed from TP1 on the board...
I would like to install a switch to control a pump via the alarm receptacle. My thought is to tap the live wire after the fuse, before it connects to the circuit board. This would bypass the mechanical relay and give me full control of the alarm receptacle.
Does anyone have a better...
I picked one of these controllers up to play around with. When it arrived, i took an extra Auber PT-100 sensor and rewired the panel end using a 3.5mm screw terminal adapter converter.
Red wires from the PT-100 were attached to the L + R terminals (left and middle terminals) on the adapter...
Jay, I have a Speidel Gas In with Pressure Relief Valve from you. It won't hold more than 3psi. I have adjusted the screw to raise the psi and it still releases at around 3 psi. I've put teflon tape on per your suggestion in the website as well with no luck.
I'm looking to put a spunding...
Here's a few pics of the HLT.
3-piece ball valves with
Recirculation port:
50' HERMS coil from Stainless Brewing
Brew Hardware solder try clamp fitting for element
5500 All SS element from ebrewsupply, brew hardware element enclosure, extended rtf sensor cable from Auber ins.
$700 plus...
The HLT is built almost identical to the electricbrewery.com HLT plans The HERMS and recirc ports are on the opposite side from what Kal does and there is a Brewhardware solder tri-clamp fitting installed for the element. The BK has a whirlpool arm and a Brewhardware solder tri-clamp fitting...
What are you looking for? I'm downsizing from an 3 vessel HERMS system and may have an HLT and BK to sell. I can give you more information if you are interested.