hello
So I set up a herms hybrid gas/electric with three burners and a 1500w heating element in the HLT. just have the gas to get strike water to temp faster on both the MLT and the HLT. Then i let the PID with a SSR take over and lock in the temp of the sweet wort. I have the temp probe on...
Hello
So i did a second brew day with my brother yesterday with the new hybrid gas/electric HERMS brew setup. I could not have built it with out reading all the great posts with wonderful advice from homebrewtalk. Everything to setting up the HERMS to soldering the stainless steel thanks.
We...
hey bob
So we brew outside rain or shine (do set up pop up canopy) . we also have 20 amps in garage, when i was putting it together i just thought turning off a 120v heating element would be the most simple thing to do, as apposed to opening a valve on the pump with continuous gas firing or a...
Hello
So when i set up my HERMS system I went with a hybrid of gas and electric. Gas to heat the HLT quickly then a medium density 1500W heater that i run on 120v and control with a PID controller from auber. I have the temp probe at the end of the heat exchange coil to measure the mash...