I have 6 of each item listed below:
4" stainless steel shank, 1/4" bore
Swivel Nut - 1/4" FFL to 1/4" barb for 3/16" or 1/4" beer line
1/4" tailpiece for shank
Hex nut for tailpiece
Asking $75 for all, buyer pays shipping. I should be able to fit in all in a small flat rate for about $7.
I just bought a Kenmore 12909, same as the 12912 I believe but black. I can fit 6 ball locks on the floor and a 5# CO2 on the hump, no collar. I was wondering if anyone knew if I can fit 5 pin locks on the floor? I have 5 ball locks in there right now. I bought Bev-Seal Ultra and John Guest...
What size batches are you making? You can get a 1500w element and tube a lot cheaper than the Blichmann rocket. An SSR needs to be rated for 20A and will need a heat sink. I like using a contactor to driven by an SSR for my element. You'll also need a pump so if you're planning on running that...
Used this for a short time before switching to a BrewPi. Wired for 120Vac with temp probe and one outlet for heat and one for cooling. Can't remember which outlet controls heat/cool but I can figure it out and label them if you want.
$45 plus shipping.
***SOLD***
8 - 1.5" Tri-clover with .5" barb
Fitting only with worm clamps for each. Asking $9 each plus shipping or $65 plus shipping for all of them.
I should be able to fit them all in a small flat rate box which is around $7