Recent content by SpudClampDawg

Looks like the recipe in the OP is solid. Without going through all 326 pages in this thread, are folks still making that recipe or has an improved version emerged since this was originally posted in 2008? Thanks for any help! :mug:

I am on the hunt for burners for my stand and am considering the Bayou BG10, 12 and/or 14s. I was wondering if these things were sold in any stores, or if they were online only? I am heading to Indianapolis tomorrow and was hoping to look at them in person. Thanks!

Yeah, all the info out there gets confusing. So, the BG12 will work, but not in the kit I linked with a 10psi regulator?

I am looking to add two burners and found these packages on Amazon. I know a lot of folks lean towards the BG14, but would either of these work? Is a 10psi regulator big enough if I am doing 10 gallon batches? Thanks...

The corner brackets (THK-233) are on backorder on StrutChannelFittings.com until the end of February. Are they available anywhere else? Does anyone sell something similar that would work? They do have a powder-coated version available for ~$1 more but would this cause problems if used close to...

Annnnd, I realize as soon as I post my question how to do it. Was thinking the bolts had to go through the hole in the cross beam strut. NM :)

Hi gifty - thanks for the gift of this thread! Apologies if this has been covered in the previous pages, but how do you attach the THK-64 splice plates to the cross beams? It isn't clear in your photo on the first page. Thanks again!