Recent content by Skullduggery65

Not sure if this would work since the gas will have probably already escaped, but you could try spraying soapy water on the tube to see if any bubbles form.

That doesn't sound good. You may have lost all of your refrigerant. Did you do this when it was at room temp?

I have a similar issue, did you ever figure this out?

Mine gets plenty cold, in the 38-40 degrees neighborhood.

Where did you drill to get the fan inside?

I did not remove the thermostat.

The ball locks are a tight fit, but they fit, I thought pin locks might fit but it sounds like they don't. That's a shame. I'm not sure about the Sanke. Good luck guys!

So I think I found the problem. I forgot to install the nylon washer between tank and regulator. That was pretty stupid, but I'm not sure if the instructions indicated it needed to be done - so in typical noob fashion, I ignored the washer that was ziptied to the regulator... D'oh! I've put a...

My fridge should be around 35 degrees but the CO2 tank feels pretty light now, when I adjust the screw on the regulator to adjust the PSI it's unable to do so and if I hit the pressure relief on the tank it sounds like much of nothing is coming out anymore

So I just finished kegging my 2nd beer, and went to hook it up when I realized the gauge on the regulator indicated my CO2 was very low. I just had my CO2 filled last week and this is a brand new keg connection system (2 keg system). My first question, is my beer going to go bad since I'm not...

What if you do not have a racking cane or barbed swivel nut?

Do you mind sharing what you did, for those of us not familiar with hopville?

I'm in the same boat as OP. Not sure I'd use Rock Bottom though, I like their beers, but always seem to get really hungover! I was thinking Cap City or DC Brau.

Some updates... my kit from Keg connection arrived yesterday. Over the weekend I finished with the 3" hole in the top of the fridge by removing the insulation there, and cutting through the plastic liner in the fridge. Be advised, there is a power cable running right through the center of the...

Update: My keg connection dual faucet tower kit has been ordered. I should get it next week and will post more pictures and updates soon. I have the original thermostat set to "1" and it's holding temps at 41 degrees but I don't have the fans installed yet. Still need some adjustments there.