Recent content by shtank

Spike Solo 15 with a steam condenser lid, DIY panel with EZBoil PID. Everything else is mostly from Spike except for the Blichmann Riptide pump and Stout chiller. I have attached an itemized breakdown below of what I paid for everything just a few years ago. I would prefer to sell everything to...

I had a solid red LED on the pi and couldn't get it to reboot, so starting fresh again. I ordered a new power supply just in case it is a power issue. My Rpi is an old one that I have had since Fuzzy started the OG thread. Is my Rpi out if date?

What exactly do you mean by "reposition"? Like physically move the device close to the router?

What's up dudes!? So grateful to see you guys still helping people make better beer! Cheers to that 🍻 So I built an OG unit Like a decade ago then stopped brewing for awhile got back in, stopped again, got back in... And you guys Lee, Day, Fuzzy and crew have helped me out SO many times. So...

Thanks for the feedback.

Awesome pictures everyone! What is a good height for the pull down faucets? 25" 36"? I have seen a lot of different sizes on here and I'm sure each has its drawbacks. Cheers

Thank you soo much Lee

During install I opted not to flash shields, now my script is not running. I assume this is the problem. How do I flash shields after the fact? Thank you

Well after many attempts and then my SD getting corrupt from pulling the plug so many times....Its a fresh install for me! I am going to install a monitor and keyboard permanently. Will I need a better power supply? I currently have the one Fuzzy originally recommended (5v I think). Will I...

I forgot what I set it as. Thanks

Anyone have any tips for resetting the rpi password? I've tried adding "init=/bin/sh" to the cmdline file but the su account is asking for a password as well, and I do not see the "/etc/shadow file". Please note that I am attempting to do this headless.

No they share the same power source.

I did hook up a monitor and keyboard but there was no picture or no response from entering the shutdown command. So I pulled the plug and fired it back up... Everything is working properly now, but what would cause this and how can I prevent it? Thanks

Not so fast... [emoji6] I have a new problem now. I came home this evening and I can't access the web interface or SSH my Brewpi. It is still maintaining temperature and everything just no access. I checked my routers device table and the Brewpi is no longer on our network. All can do is...

I switched them to not inverted and it appears to be running properly. I will run a fermentation schedule this week just to make sure, then it will be time to brew... [emoji482] Thank you everyone and thank you Lee for BrewPi legacy remix.