Recent content by sethhobrin

Does anyone know of any 240V elements that are around 2000watts and stainless? My setup is all 240V.

Bobby will you have a 240V/~2000 watt version for rims tube?

Any low wattage 240V element? I am looking for one around 2000 watts that runs on 240V for a RIMS tube.

2 Years later still going strong! Haven't change a thing since completing this build. Thanks HBT!

I am still searching for a 12" long ULWD 240V 1500Watt/2000watt element for my rims tube. Lots of choices for 120v but not so much for 240v. I have a 240v circuit.

wow thanks guys! i already have some lactic acid and on my last batch i used my meter to determine PH and added about 3ML of lactic to drop the PH down to 5.45 so it sounds like I am on track. Sounds like I might need to pick up some phospheric acid instead to minimize flavor impact. What PH...

ppm Sodium, Na 10 Potassium, K 2 calcium, CA 38 Magnesium, Mg 12 Total Hardness, CaCO3 145 Nitrate, NO3-N 0.2 Chloride, Cl 16 Carbonate, CO3 6 Bicarbonate, HCO3 116 Total Alkalinity, CaCO3 105 Total Phosphorus, P 0.38 Total Iron, Fe < 0.01 I checked out the primer...

Few more pics before inaugural brew day on Sunday. Brewing a 1.079 Rye IPA! My starter is fermenting away!

I would have let him crush it and then told him to keep his grains since the crush was not good enough and walked out...

i thought i read somewhere that this is not necessary. the element won't melt the nylon hop bags. please verify before taking my word for this.

Ok I lied... one MORE change.. added an elbow at the CFC outlet so the temperature gauge doesn't stick out so far.

One last quick change before first brew day. Didn't like the CFC just resting on the bucket so i mounted it to the brew stand with bolts and thumb screws for easy removal.

Here is my setup. Just completed it. Going to mount the CFC with a bolt to the brewstand this weekend but otherwise done. Full build thread and photo album in my signature. Shot at 2012-07-14 My Electric Brewery Build...

I am performing a mock brew day right now to fine tune everything. Halfway through my mock mash! :) First official brew day scheduled for July 29th with my brew buddy! Here is a pic of the completed setup.

i meant for the threaded connections that have a slight leak with tape. I was considering using putty for those 1 or 2 connections. I have spare orings so I'll give that a try on the QDs.