Recent content by saulverde

I know where you are coming from. I was fully prepared to make it a 5 tap system on build day if needed. It was close. When I planned it I had 2" front to back clearance and less that 1/2" side to side. The interior of the fridge seems to narrow as it goes up. I have the 1/2" at the bottom...

I just checked and the way it is in there now, the co2 cylinder is pretty snug under the shelf. any pressure I applied seemed to transfer to the bottom of the fridge without any flexing of the shelf. I'll just have to be sure to remove the kegs before changing co2 tanks.

That is a concern but I won't know until they are in there. If it's going to break it will be in the front center. I may put a wood support there just to be on the safe side but the front of the shelf has a metal bar across for support. I'll let you know how that goes this weekend with I load...

A two way regulator, two three way gas distributors with valves, 43’ of ¼” beverage line, 12’ of 3/16” beverage line, 12 ball lock connectors(6 gas, 6 beverage), 30 hose clamps, 10 lb co2 tank, 6 faucets, 6 tap handles, 6 four inch shanks, 6 shank nuts, 6 ¼” barbed...