Recent content by sabo38

Its an inline chugger pump. it sits about 10-12 inches lower than fitting on my kettle. the hose from the kettle to chugger pump is not extra long where it lays on the ground either. Just seeing if anybody else has made a fitting for that purpose. Otherwise i think ill just by a 1.5 tri clamp 3...

I'm brewing with a Colorado Brewing system. I'm having issues where the pump will not pump because there is air trapped right before the pump. Does anybody know of an air bleed valve that I could put in front of the pump so I can bleed the air without taking the tri clamp loose and let the air...

I am looking for a 10-15 gallon stainless conical fermenter. I live in southern Minnesota so if pickup is an option otherwise I will pay for shipping.

Got the pics. Talking with my business partner. Where in Iowa are you located?

Can I get more pics. Just email them to [email protected]. Thanks

I'd be interested in 1. Looks like a great product and I am in the need for help on fermentation temp control. I work in New Ulm so I'm right in the neighborhood.

.045" is what I have mine set at. I usually run my pump around 1/2 depending on how everything is flowing. I have not used rice hulls yet but I think I will in the future so I can recirculate a little faster, it seems the better it circulates the closer the temp between the sensor and grain bed...

He already emailed me back. It's covered under warranty so we'll see if the 2nd one holds up better than the 1st.

It died altogether. I plugged it in this morning just to make sure and it's dead. Had to deuce over to my regular pump during cool down was not easy either. I had no shutoff between the pump and my kettle so I had very poor flow through the little pump. I am gonna email Tim and see what my...

So that little brushless pump that they sent us is a total POS. I've used it for less than an hour and it's already fried. I was sending my wort through my chiller and all of a sudden it just stopped pumping.

This is the whirlpool fitting that goes in the whirlpool port on the bottom.

Is this what your looking for?

So do you add 3 degrees to your mash temp? I would think if you were off at the top you would probably be off at mash temp.

Mine should be 212. My grain bed temp and PID are about 3 degrees different so I think if I would bump it up 3 degrees I would be pretty close to mash temp.

Where do you find how to calibrate temp? My PID shows 209 at boiling and I need to add 3 degrees to it.