Recent content by rukkus

That’d be awesome thanks

Battery monitoring circuit working for me, it would be a slightly simpler build for the floaty of pin 32 was used for the battery monitor as 35 is hidden by the sled and I hat to cut it slightly. Regarding the angle of tilt, in water does it need to be 25 degrees like the ispindel or can I...

I just lay mine flat on the table and it enters configuration mode. Sometimes I might have to push the reset button first.

I’m also going to add the battery monitor while I have the soldering station setup. Does the 470k resistor connect to gnd on the esp32 or directly to the negative on the battery?

Actually never mind, if I calibrate it with the gyro facing flat it does work. My calibration was with the board perpendicular as it lays by default. Sorry for the waste of time and thanks for the help and awesome project.

I just soldered up a 2nd one to check for a hardware issue and it’s exactly the same as the first one. The gyro is a GY-521 MPU-6050.

Hmmm, maybe I’ve a faulty gyro then or something.

Thanks, I just flashed a new version reading the angle using the other axis but it resulted in similar behaviour. When I move from flat 90 degrees to standing on its cap it shows 60 degrees. Feels like it might be a sensitivity setting or something.

Thanks, that’s most likely what I’m seeing then. Mine is orientated like this

I updated my floaty to 1.4 today but I’ve noticed when I place it on its cap it thinks it’s at around 60 degrees. If I tilt it it seems to never reach 0 degrees. My floaty uses a v2 design sled where the gyro is perpendicular to the battery but still located to the top of the tube with the...

Does fermentrack work with BrewpiLess. I have flashed BrewpiLess to a sonoff th16 but it seems port 23 never opens so fermentrack cannot connect.

Did you find an adapter in the end? I also have a guinness tap that is too tall to fit in my fridge.

Hi, I've been thinking of ordering a braumeister but I cant decide between the 20l and the 50l version. I'm living in an apartment and I'm limited by space so I only brew 5 gallon batches. I would be looking to brew some high gravity beers though (I tend to drink IPA/IIPA). Would spending more...