Recent content by repetesbh

Is the hosehead controller still available?

How much is this?

Did you sell the hosehead?

Is this still for sale?

Thanks for the reply. It took some updating of CBPi3 coding and figuring out how to detect the new probe to resolve the issue. I'd rather use Elsinore than CBPi3 because it wad easier to dial in boil temps, but reloading a SD card with CBPi3 and the updated OS for Raspberry Pi.

Where in MD are you?

Here is a view from the propane days...

This pic was from a few years ago running a heating and pump test through my HERMS HLT. I've also run this stand using propane and a RIMS tube.

PM reply

The good old US of A! It's been a little psychedelic...everything I open my eyes it's something new and weird.

A sensor issue is better than I thought. How do you change the address associated with the sensor?

My Hosehead just started reporting it could not find my sensor for my yellow/BK. It still recognized the HLT and MT sensors. I think I have either a corruption issue or a bad sensor. How difficult was it to replace the sensors? How much reprogramming did you need to do? Any help/advise would be...

I don't recognize the controller. Is this a wireless/headless controller?

Elj, I just got the same error message for only one temp probe (boil/yellow probe). Were you able to determine a way to fix the problem? I'm running SBE. I've shutdown my Hosehead, and removed the elsinore.cfg and log with no success. I've unplugged each of the sensors one at a time and all at...