Recent content by pogolounge

Hey everyone pin locks are all accounted for, sorry.

Hey everyone, I have 3 sets of pin locks from Spartanburg kegs and 4 from cony kegs that I converted to balls. Not looking for cash, just supporting the community, let me know if anyone can use them. Thanks.

No worries, it will be fine

Thanks again everyone!

Thanks, I couldn't come up with a reason why it would be bad either.... just regular home brewer paranoia and needed some reassurance.

Main reason for 170 F was to stop enzyme activity, thanks.

Hi everyone, Getting long chunks of time for brewing is becoming more of a challenge every day. Yesterday I tried something new and couldn't find much info on potential wort impact. In the morning I performed my mash as usual, sparged and collected everything into BK. But didn't have time to...

Hey everyone, raised temp up to 75, still no activity. Do you think I should raise a little higher, wait another day at this temp or try and pitch some more yeast? Thanks.

I think I definitely had good aeration, used a stone for about 5 minutes until it foamed up real good, the temp definitely stays constant as I have a control system taking care of that, I will see if the increased temp gets things going and report back. Thanks again, I really appreciate the help.

Thanks everyone, it was a dried malt extract 10 gallon batch, pitched 2 tubes of white labs wlp380 into 71 degree wort, just went out to garage and dialed in new temp to raise 10 degrees. I will post back with results. Thanks again.

Hi, OG was 1.055, vigorous initial ferm for 2 days, after 2 weeks down to 1.025 and seems stuck, in a conditioned chamber held at 67. Any insight would be greatly appreciated. Thanks.

Thanks for taking the time to check it out, I appreciate it.

I was racking my brain on your previous post! I could have brought in 50A but I already set up my garage a year ago with two 30A outlets, so for ease I am pulling off of them. Thanks again for your review!

I just looked at this again since you are definitely making me think. Take the HLT for example, since HLT #1 and HLT #2 are fired by 2 different 220v lines, I need both relays, same case for the BK. Even though I have the selector switches, I think I still need a gate to control where the power...

They are rated 40a, but I don't think I can eliminate them because I need a way to call for power from either the HLT or BK, if I scale back to 2 relays how would I be able to communicate all four signals for which element I am firing?