Recent content by NRF

Nice job Tarpon!

Mine is the same. Once you start running some grain it actually runs much smoother. I needed a metric bolt for the auger.

Thanks to all who have contributed to this DIY. You have all seen this version already. I trimmed a little more off of the water jug then I was able to slide the bottom back on to make a hopper cover. No big deal. Glued a hunk of scrap to it for a handle. Large paint stir sticks fit snugly to...

No. These are not ported. Bigfloppy you have a PM.

I have two new, never opened six gallon better bottles. $20 each plus ship. I would ship UPS in the original packaging as they were shipped to me from northern. PayPal only please. Shipping from central NJ. Thanks for looking.

Yes please.

Please count me in! Thanks to all the vendors here!!! :mug:

Excellent! :rockin: Tossing my idea out the window- this is perfect. Well played Sir!

Mine too is drilled way off center. I have not tried it yet, but my thought was to chuck up a rod, bolt, whatever... into the drill then find HD rubber hose to fit the rod and the mill shaft bolt and clamp them secure. Hopefully it will dampen the wiggle enough. We shall see...

Brew well my friends!

Nice set up.. Hope you don't have a cat though...:p

Buzzkill...:(

Yeah- it's a real biotch with 10 gallons too!

I have yet to build this myself, but intend to do so soon. Just be sure the pump you purchase has adequate head pressure / lift for your intended set up. I love the swimming pool idea- :mug:

Yup- my bad! I always see bottle openers... :o Nice job on both of your mills guys! :mug: