Recent content by ncgardenfreaks

Been looking into getting a chugger stainless pump or two and they seem to have disappeared. There site shows some march pumps and nothing on ebay. Anyone know if they are still around or another place to get them? Thanks Rick

you could go down a size on the punch and not have to drill as much with the step bit.

tigmaster you said use tri-mix gas for MIG process on stainless, I do stainless welding and fabrication for food service and have not seen the reason to use tri-mix. Argon is required for a sanitary weld with that process and not the uni-mix junk. I hate to even say use a MIG for sanitary...

that pump would indeed be overkill. I have one and use it in for pumping liquid ferts in my competition pumpkin patch. Hooked to a waterhose with a stream nozzle on it I can cover a 35 foot radius area. Good pump but it moves alot of liquid.

agri supply is the place to buy banjo burners. BG-14 burner $29.95

those valves will hold any temps we could through at them. They sit right on top of near boiling water in the tank that we return our exhausted steam and condensate in to recycle the water. The minimal id in the 1/2" NPT valve like this will pass a 5/16 ball completely through it. Last I...

Here are parts like we use. You can probibly get them from McMaster Carr or somewhere else, we normally just order from here though. Valve: http://www1.mscdirect.com/CGI/NNSRIT?PMPXNO=13135635&PMT4NO=93982878 Copper float: http://www1.mscdirect.com/CGI/NNSRIT?PMPXNO=7211479&PMT4NO=0...

I'll look up the parts we use in our condensate tanks at work and post them here. They stand in 215+ degree water 24 hours a day and dont stop up.

A sawzall will work fine.

Look for an inline duct booster fan. Sometimes they are added to a heating system if there is a long run of duct work and the airflow is low. They can handle gas heating systems which can run 100+ depending on how they are set-up. Should do what you are looking for. Just my 2 pennys though.

Hey Jay the FBs look good, I have a few ?'s on the 15.5 hinged ones. Are they all 304/316 stainless hinges and all? What guage are they made from and do they need braces under them with a large grain load?

All stainless isnt the same so they could be used or not. Some series stainless have a higher carbon content, and other additives for different uses. Check it will a magnet if it sticks then it can rust which would suck. I see rusting stainless in very high $ equipment in the food service...

If you are getting resistance from the poles on the compressor to the casing then the motor in the compressor is shorted to the case. Mark and remove the wires from the compressor and recheck the poles to the case. If you still get resistance then it will have to have the compressor replaced...

I work on commericial resteraunt equipment and coolers for a living so I may can walk you thorough some of it. Most of those coolers dont have a pressure control on it to know if its low on gas or running to high of a pressure. More than likely it is the overload on the compressor called a...