Recent content by mazultav

https://www.homebrewing.org/Draft-Arm-Wrench_p_5431.html Both options.

Just built it today, my keg and beer line cleaner.

I always thought that the astringency was from over sparging and extracting tannins from the husk. Which is one of the reasons BIAB guys can get away with a finer crush (no sparge).

Zero. I just hoist my bag out of my ekeggle. I guess I do a hanging spattered for about 5 mins. 70 to 75 percent without squeezing.

To the OPs question, Nope.

Go for it! I did one canned extract kit, one dry extract with grain kit, straight to stove top biab with my own recipie, to about 15 all grain with a cooler mash tun and Turkey burner, now I'm back to biab but now in a electrically charged recirculating kettle. Only you know what's right for you.

if your truly going to ship could you unscrew the posts and then screw on some sort of cap, to remove the possibility of the poppets being pressed in?

How about something like this? http://www.ebay.com/itm/2-RED-JEWEL-110V-PILOT-LIGHTS-LAMPS-INDICATOR-THR110-/300623715540?pt=LH_DefaultDomain_0&hash=item45fe91dcd4#ht_1008wt_754

Looking for a food safe pump for my almost finished e-biab rig. March, Chugger, Little Giant, etc. Thanks.

I went back and check with my multimeter, no voltage on the switches. Thanks everyone.

Right it's a tester with a single probe, looks like a futuristic pencil, and when I put it near the actual metal switch, not just the terminals it lights up.

Not sure if anyone had seen these yet? http://www.bayou-classic-depot.com/bayou-classic-brew-pots-s/1871.htm Looks like stainless, with a lid, spigot, thermometer, false bottom and some kind of hop filter.

OK thanks. I think I knew that, but a flashing red light can give you The Fear.

I have just completed my EBIAB control panel. Its a single PID, single element panel. 30A 240V. After the first time turning it on I was poking around with a voltage detector. My SPST toggle switch which is rated for 30A and only flip a 120v coil for my contactor cause my detector to light up...

Any ideas where I can find 240v 50A terminal blocks?