Yup, the drilling part is where it gets difficult. Putting a 3/4" hole through a 1/8" thick stainless TC cap is not as easy as it sounds, at least without the 3/4" cobalt bit and a drill press.
Totally agree of the shelf would be cheaper, I've looked everywhere, and unfortunately I need a 1.5" TC fitting with 1/2" NPT female on both sides that doesn't seem to exist. I guess I'm going to end up building it by tapping the NPT threads on an existing TC connector.
Building a CIP spray ball setup for my Chronical and would like to attach to the 1.5" TC on the lid. Need a hole cut in a 1.5" TC end cap so the 1/2" NPT male QD fitting can pass through and attach to the spray ball on the other side. Anyone have access to a water jet / machine shop and could do...
Just wanted to say thanks for this project! While I'm not using it in the traditional RaspberryPi setup, I was able to get it installed and working on my GoDaddy shared hosting account and use it from my tablet via web browser. Had to tweak to get it compatible with PHP v5.2.x (no support for...
Jon,
Which neon markers are you using on that black dry erase? I've been through two different sets of markers on mine and they don't show up worth a crap on the black board.