Our apologies. We just made the swap over on the site and are trying to migrate and update information. We've also just updated the product offerings so there is a significant amount of updates needed. If you have a question feel free to give us a call and we hope to have the rest of the content...
The sensor measures the amount of pressure caused by the height of the liquid in the vessel. There is air in the line as the sensor does not directly contact the liquid. When the temperature increases the excess air bubbles out but the reading is still accurate. However when the temperature...
Obviously as one of the developers for BrewTroller I'm biased. I do think the DIY component of BrewTroller is made into a bigger issue than it really is. The BCS comes with an enclosure and power supply and the BrewTroller doesn't. Both the BCS and BrewTroller require you to wire up your sensors...
dozer: Absolutely. I was referring to the item in the intial post.
If the intent was to go toward BrewTroller, spending $40-60 on a temporary alternative versus the $80 for BT might not be the best choice.
BTW there is a PC companion program (BTRemote) for the BrewTroller if a full PC...
This isn't much cheaper than a BrewTroller. Keep in mind you don't need to use every feature of BrewTroller when you start. You can use it to monitor temps and control a few pumps.
BrewTroller does this though it's not something that's been tested very thoroughly yet. We use the Freescale MPX5010 sensor and a calibration table in setup where you calibrate specific analog voltages to known volume levels. We take into account atmospheric pressure by reading a zero volume...
Has anyone figured out how to make a cheap steam jacketed boil kettle yet? You could eliminate the elements in the boil kettle and use a boiler for direct mash heat and to feed the kettle jacket.
Our source is your source so feel free to use whatever is valuable for you. For my system a standalone setup was a requirement. I don't want to bother with trying to sync up with a PC local or remote. I just want to turn it on and go.
As for loading of recipe data... I'm working on the input...
PhylanPan, We will put together an itemized list of parts and costs for each. A big variable will be your system design. How are you heating your HLT? Do you have a recirculating mash system? etc.