Recent content by lincoln

i'm in

It has been a while since I went through "pump class" (yes, an entire class devoted to centrifugal pumps. ) How big is the diameter of the impeller? How much are you enlarging the suction side by? Is it an open impeller design? (can you look in the suction and see a swirling pattern? On such a...

have been looking for it but didn't know what it was called. Every one i talked to just looked at me with a blank stare. Thanks!

there is also this: https://www.homebrewtalk.com/f35/cure-your-short-hose-troubles-100151/

1/2 " will be fine, provided its not a 30 gal mash tun... :p

Hello Yuri, I have a similar project... well ok sort of similar, Monarch 10e-nc with dead controls. have every thing I needed to get it together but looking at the break out board I orders is is limited to 10 khz. (i really wanted and optical isolated bb) I'm thinking that is not fast enough...

I think it only comes with one, some where else on the page it has a package for the other two remotes.

I have an older version of "Silver Indoor and Outdoor Thermometer - Weather 200 Model # RMR202S" from http://us.oregonscientific.com (edit> sorry, direct link not working) it will measure and keep track of highest and lowest of three remote sensors and where ever the box is sitting.

What Chris7687 said, It is far form the most efficient setup but it will work. An ideal setup would be a controller with both a heat and a cool set of contacts but its on such a small scale it will work ether way.

hate to bust your bubble (so to speak) but " ..other low pressure applications.." this will mean that you will need a huge diameter air cylinder. take a look at : http://www.mcmaster.com/#standard-air-cylinders/=jd0qla, a 2 " cylinder can get you over 250 lbs but thats at 100 psi. Do you keg...

I saw on here some one is using a load cell. After seeing that i use my shipping scale under my mash tun.

I draw schematics and layout pcb with gEDA tool. with that you can etch your own or another option is the pcb group buy here: http://dorkbotpdx.org/wiki/pcb_order/

Awesome! Welcome to the site. My in-laws live about 10 min away from you!

How I imagine the beer style police would look like:

I'm working on one, so far i have the rollers done. I made them out of sprinkler pipe. The frame I plan to make out of 6061.