Recent content by KKreisler

Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum

Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. K

    Anyone using 1/8 hp pump for keg cleaner?

    I bought the same pump last week, it works fine.
  2. K

    Calling all those who know about fridges!

    I am not certain, but I suspect the the original thermostat was in the small freezer at the top of the mini fridge, and now the unit is trying to cool the whole mini fridge to that lower temperature with the cooling plate. So if you plug in an external temperature controller like a johnson...
  3. K

    Keezer build

    Thanks for the complements, I will try to snap some more pics later, but to answer the questions The when I cut the pieces of stainless I drilled and countersunk the mounting holes. I attached the controller plate over the existing t-stat opening in the front of the freezer with stainless...
  4. K

    Calling all those who know about fridges!

    there are two options, you could either wire the new temperature control circuit in series with the existing T-stat switch and set the existing thermostat to any point colder than the new temp controllers setpoint , or you could remove the existing t-stat switch and replace it with the temp...
  5. K

    Keezer build

    School Pride, Props go out to the Bulldogs too, just not as enthusiastically :D Solo, I drilled through the collar to attach the taps, the only penetrations I have made in the actual freezer are the four screw around the stainless plate I mounted the temp controller and the LED to. The...
  6. K

    Keezer build

    To avoid drilling into the rim of the chest freezer I ended up using scotch high density foam mounting tape. I believe the spec on the tape was around 2lb / sq inch. I adhered the tape around the entire perimeter of the collar leaving the paper on the back side. I next set the lid on the...
  7. K

    Keezer build

    A few pics of the new keezer. there is a Caribou slobber brown, and a sierra nevada clone carbonating right now, I am going to add a rootbeer or a cream soda to the mix for my sons (and myself) today hopefully.
  8. K

    Hello

    Hello all, I have been on the forums for a little while now, just getting around to introductions. I am a 30something male from farmington MN, a city just on the southern fringe of the twin cities metro area. I am married for nearly 10 years, and take great pride in my 2 boys, a two and a six...
Back
Top