Recent content by kimeye01

Excellent, thanks!

My keezer temperature is not regulated yet so I am force carbing my beer (with the set and forget method) at room temperature (70 degrees) and will later cool the beer. My question is, what temperature should I use to gauge how much psi to apply during force carbonation? 70 degrees or 40...

This is good information to know. Thanks! FYI: I tried it last night and it wasn't nearly as bad as I was prepared for. In fact, I rather like it.

I've been fermenting a poorly boiled brown ale for over 1.5 years and finally kegged it. I didn't have hopes that it would actually taste good however I want to make sure there is no potential for physical illness. Any ideas about this?

I have been using Oxyclean to clean my fermenting bucket, corny kegs and tubing after every use. Is this too frequent? Are there any health issues to worry about?

I need to get a bigger wrench and give it another try. If that doesn't work, I'll try to force the sanitized water up the tube and hope for the best. Thanks for all the advice!

Does anyone know how to sanitize the dip tube in a corny keg without using gas? This is my first time kegging. I haven't filled my Co2 tank yet but want to get my brew out of the fermenter and into my keg so I can start a new batch. The only problem is I'm afraid if I don't get my dip...

Hi, does anyone know where the coarse adjust screw is located on a GE 7 cu ft freezer?

Haha, true. I will try again tomorrow then. Thanks.

I opened the lid of my fermenter briefly today but sealed it back on. Will my beer still be good tomorrow to siphon into a keg? Or do you think that the oxygen has ruined it? I am kegging my beer for the first time and realized after opening the lid of the fermenter that I wasn't fulled...

I've been reading about how to build a kegerator or keezer and after bargain searching for the supplies I still find that I'll need around $500 to make the thing. Alternatively I have found functional kegerator's selling for $500. The question is: If DIY kegerator/keezer costs about the...

Bobby M, I'll check prices for the compression to NPT...although first I need to figure out what NPT means. National pipe thread is my best guess based on google search. Sorry...I'm obviously not so handy. :-(

What do you mean you flared the ends? Inward or outward?

I made a 50' copper wort chiller and the connection between the copper tubing and vinyl tubing is leaking (water-in/sink side). I used a hose clamp to connect the tubing but it doesn't seem to be strong enough to prevent a leak. Does anyone know a better way to connect the two so that...

What does "IC", "CFC" and "DMS" mean? I'm not so good with the acronyms.