Recent content by jonnydot

21 day's before the chickens hatch ,these eggs are from my own birds but if I was to sell them I could about $75 a dozen ,and my old incubator was full already

Fixed the calibration it is now reading 0.0 or flashing an odd 0.1 for almost no time at all (less than a second) in ice water YAAAH .., I also changed the outY to 3 and changed the HY to 0.3 and then changed the SV to 37.5 ALL is great the unit now heats until 37.4 and waits till it just...

As it turns out when I rewired it into the incubator ,I stuffed up and connected the live wire from the bulbs direct to live and not to the SSR ,silly me lol ,the probe configuration is set to P10.0 so now it turns on dims near set point ,turns off for a sec or two back on again ,dims etc as it...

The out put light is off ,yes read the manual ,but having trouble grasping concepts , ran auto tune again all night and this morning the PV is 44.3 Centigrade which is 7.4 degrees C above SV ,...sv is 36.9 Centigrade and I have tried to change the PSb ,but it will not allow me to put in a...

Thank you for the add ;...I have a AUBER syl-2362A2 PID ,I have calibrated the pt100Mn and is point 6/7 of a degree out ,how do I input a negative point 6 (of a Degree Centigrade) every way I do it gives it a + influence ....Second Question I have ; the SV is set To 36.9 C but it will not...