I have 2 parts for sale
First is a Brewers Hardware 1.5" TC sight glass. I bought this and ended up going a different route. Was only used once and then removed from the system.
SOLD
Next up I have a Millipore stainless filter housing with 1.5" TC fittings on each end. it also what appears...
Up for sale I have a Bilchmann therminator, I have switched to a single vessel with a built-in coil so this doesn't get used anymore.
Comes with the mounting bracket and 2 FPT to 1/2" tubing nipples.
Needs a good cleaning and the label has a couple scratches in it.
$160 shipped
SOLD
Up for sale I have a March 809HS
Pump worked fine last time I used it, I moved to peristaltics so I don't need it any longer. This is the version with the 3ft cord, I put a 3 prong plug on it.
$95 shipped to the US
One thing that is very important, make sure your not using PID on any of your gas valve heat outputs, because the chatter could be the PID trying to ramp down as it approaches your temp. It could cause some major issues if it's trying to PID a mechanical relay and gas solenoid.
Also as far as...
That's fine, I just wanted to make sure it wasn't a request that we missed.
Would it be possible to get either an order number or just a list of the hardware you have so I can better go through it in my head and also what release and build of the firmware are you using?
Hey Cryptochronolite
Has the BT been acting up on you? or is this just a consistency issue between batches?
You are always welcome to give us a call at the oscsys.com store if you need help setting something up or if you are having an issue with one of our boards.
Well I found that since my fermenter is much lower than my kettle and the recirc valve is open that the wort follows the path of least resistance and never goes back into the kettle.
Should be any day now, they are currently in transit.