Recent content by Isley

Thanks for the chance!

In! Thanks for the chance!

Using a pump or gravity? I've got an old copper version of that sparge arm that works fantastic with a pump, not so well when using gravity.

Where did you get the fittings from? I've done a little shopping around and noticed there's quite a range of prices out there.

Try flipping the nut around and see if that secures it. On my grinder the nut is concave on one side and I have to use that side facing the cutting wheel when using thin disks. If it's a thicker one (grinding wheel) it will secure it regardless of what side of the nut faces it. If that...

I'm glad to see that I'm not the only one that's done this. I was going to just relieve the pressure on the keg. Had beer shooting all over the place, it was quite the mess. This won me our club's 'Lite Weight' award last year. The lesson(s) learned were to not tell ANYONE about events...

Now that's a tank. I like it. 2" square tubing? or 1.5"? Curious to see how the control thing turns out. My grill is in storage otherwise I'd run out into the garage right now and look at that.

What are you using for a filter? The thought of using the O2 from torch setup that I have has crossed my mine from time to time since I already have it.

I know a couple of people using a pump from a dishwasher. Don't know where they got them but they seem happy with them.

Do you run into any issues losing the siphon with the union as the connection? Good tip, I wouldn't have noticed that the first session or two. Did you have to unscrew the coupler first before pulling the FB out? Just found out someone in our club went the same route as what I was...

I've pretty much decided that I'm going to splurge and get the false bottom that Sabco makes. However, I am having a tough time justifing dropping the coin on the universal siphon that they make. Am sure it's nice but can buy a lot of copper and grain for that $$. My thought for a siphon...

Great tip on adding the nipple inside for the sight gauge. I'm in the process of figuring out what to get welded on to my keggles. Saved me a headache or two. Question regarding the temp probe though. I was planning on a 1/2 coupling for that. How durable are those thermometers (I'm...

That sounds like a Hoff-Stevens keg. I'd pass as handles are nice to have...

You could put a couple of pieces of flat steel on the ring and then place the keg on those. Have seen that done once or twice. Probably not a permanent solution but would get you by until one presents itself.

X2 My last purchase was just under $20 each shipped. Had to get 25 of them but didn't take long to get rid of what I didn't want/need.