Recent content by Islandboy85

Nice! What size tubing is that? 1in square with 1/16in wall?

It stores pretty well next to the stuff shelf and toolbox.

Ok, we have the unistrut brew stand thread, wood and metal brew stand threads, but I haven’t yet seen one dedicated to the compact mobile specific. I know many people share my own issue of limited storage space, or having to brew in an area other than they store the brewery. So, I’ll start. I’m...

Nothing was plugged into those plugs. In retrospect I should have tapped the power on the downstream side of the contactor... thanks.

Started smoke checking the system. The safe start interlock relay had issues due to the silkscreen ID on top of the relay, stamped ID in the Boynton if the relay, and the relay socket all having at least one error each not matching the data sheet... thanks a lot Uxcell. The power meter ended up...

First off, having been born outside the US and lived there until my late teen years I can agree English is tough, but yours is fine! Congrats on the build! It looks good.

A good friend of mine that brewed a 3-1/2 barrel system for almost 15 years, and moved to his own brewery if 14 barrels said that’s getting into the range for steam heat.

That was a good tour, and I agree. Unfiltered Bud is great. Once it’s processed and packaged not so much.

I lost 9 bottles. They fragged glass from the spare bed room, down the hallway, and into the living room of our old apartment. There was still bits of glass I found when we moved out. Lucky for me I have bought a wed dry vac that week. I switched to kegs after that. WAAAAAYYYY easier. Want to...

I will also say having bout 6 Meters of PT100 metal stainless braided cable that stripping the fiberglass inner insulation off the conductors is a bit of a pain. I’m starting to figure out some tricks.

For a lot of my low voltage, temp sensors, float switches, and float switch bypassing switches I used scrap M27500 aircraft wiring. Most of it was shielded twisted pair, but I was lucky to have a little triple twist for the temp sensors. I like this stuff because it’s Teflon jacketed and can the...

Just need to bond all the receptacles time case ground, and the inside should be done. Hopefully I’ll get that knocked out tomorrow, and start on the wire harnesses. Still have to fab the HLT. HERMS coil is more or leas shaped. Also borrowing a MAP torch this weekend to try silver soldering up...

Got everything tied up nice and neat.

Got both SSR installed again with thermal grease, and the seal installed for the panel.

Any updates on LHBS carrying your malt?