You made your own temp probes?.......Hhhhmmmmm now that has me thinking....did you flare the end before you welded/soldered it to the TC end cap?
I know your going the Adrno route.....Will these also work with PID's?
Going to be dropping you a PM.
Hey keep posting. I am currently using propane for my heat source. But at -40 it is becoming a PIA. I downloaded Kals pdf. I currently have a HERMS set up. But have been looking at a RIMS set up also.
Brewers Hardware has nice TC items. Take a look at Stout Tanks. His looks pretty nice...
SCORE!!!! Those are sweet. I never have thought about that type of covering on the wires. Hey JRems, what key word(s) did you use to find them on DBay?
Hey PJ, hope you are feeling better. You are a asset. Hey, I have had the same motor for a couple of years now. My intended use was to stir the Mash Tun while the grain is mashing....didnt do it.
How did you wire that motor up?
Yep, living in North Pole Alaska. Will take beer bribes to get anyone on Santas "good" list. As a matter of fact we hang out at the same lounge. The Elf's Den..lol.
There is a few of us homebrewers up here.
Thanks for the link.
Hey Sils, like you I am starting to pull the trigger on an Electric build. I bought Kals book for ref.
Have you been keeping a XLS spreadsheet or something of that nature that shows where you purchased your pieces from?
Great build so far. Keep it up.
I use the same element enclosure for my distillation. I am thinking about converting to electric now. Your build makes thing look a little easier. Deff has my attention.
I have thought about this also. I use a 10 gallon round Gott cooler. I installed a thermo well in the middle of the tun. Then also installed on down by my ball valve at the bottom. You will be amazed and the temp differantal between the two. But, the middle thermowell is where I put my temp...