Recent content by flyguy340

I've got two sanke kegs that I plan to start using soon as fermenters. My question is how do you guys acurately measure the quantity of wort inside the keg? or do you just take the measurement inside the boil kettle prior to transfer to keg. Thanks for any thoughts and ideas

Any pictures of your grain mill?

Do u have any pictures of your setup?

Thanks for the info, I'll look into what you did. I don't have a motor yet, so this is good info.

I'm thinking of purchasing the MM3 1.5" roller, any opinions on that mill would be great. I'm looking at a geared motor that is rated at 40 inch pounds of torque and 178RPM, is that enough power? Thanks for any info.

Hello from the south metro!

Most likely your regulator is more then adequate for your volume needed. Do a google search for your make/model of regulator and you should be able to find what the BTU output is. I have a similar setup, 2PSI gas from the gas meter then its reduced to roughly .5PSI and then manifolded to...

Looking awesome!

Just got my burner stands together and am curious what the optimum distance is from burner tip to the bottom of kettle. I'm using 10 tip Natural Gas jet burners rated at 75K BTU. Thanks for any help

Sorry for bringing up an old post, but I'm curious if anyone esle has thoughts on this. I'm considering the same idea for a cold box.

Thanks for the info. I have 2 PSI gas running from my meter into the house then its regulated to 7-11WC in my furnace room and distributed to the appliances. I plan on running an additional gas line to my burner area, probably about 30' plus another 5-10' to each burner- just was concerned...

Hi Guys, I bought these 10 Tip Natural Gas jet burners and am wondering if I should run them off regulated N.G. 7-11WC or High pressure 2 PSI? I have access to either, just depends how I plumb. Thanks for any info...