Recent content by EarthBound

I know they're old, but these posts caught my eye regardless. If you are interested in why it's perfectly fine to use bags with elements, read this thread: https://www.homebrewtalk.com/f170/contact-element-224084/ Cheers! :mug:

What's the wattage of the element? I dry-fired a 5500W 240VAC element. After doing the math, I should measure 10.5 ohms. Sure enough, the element I didn't dry-fire measures 10.5 ohms. The one I did dry-fire measures about 10.8 ohms. After doing the math, I will have a reduced wattage of 5333W...

Finally building it tonight! :mug:

http://www.bluto555.com/2010/12/double-barrel-process.html

I have almost all of them. With his permission, I could upload them.

Your brewery is amazing. Excellent work, man. I plan on installing the same float switch for the same reason. :mug:

Could dry-firing an element increase the resistance in the circuit?

https://www.homebrewtalk.com/f14/swmbo-vs-homebrew-164813/

My control panel is mounted on a very beefy modified monitor stand, attached to the brewstand. If I could mount it again knowing what I know now, I would mount it to the wall.

What an awesome rig! Excellent work!

Yes, unfortunately for many people on HBT, this does require a little bit of thinking. All kidding aside, I set the HLT a few degrees higher than the desired mash temperature, and I continuously recirculate the HLT to ensure a consistent temperature throughout the HLT. Insulating the MLT is...

The resistance in the circuit can increased through a poor/loose connection. There are many ways that this could be done. I noticed that the most likely culprit is the connection to a relay or terminal block. The screw that holds the terminal down can be loose to such a point that the ring/spade...

Sweeeeeeet.

Do the 50A circuit. You won't regret it.

Glad to hear that it still worked out ok! Maybe the name the beer after the event? What kind of beer was it? My rig is hybrid (electric/propane), and I always have propane regardless of my utilities.