Is the Reducer just hanging off of the motor as it is bolted to the face? Or do you have a block under the reducer as well and have that bolted into the base?
Drunkenmonk, my good man. Quick question. I have attached 2 photos. The show the height difference between 1) the Motor (leeson with base) and the speed reducer and 2) the speed reducer and mill.
Is there an EXACT hight difference that would allow me to go buy corresponding blocks to put...
About to finish sourcing my similar build and struggled to find a well priced 1HP Motor with these specs: 56C, Cap Start, Base and Face Mounting - Alas I found this...