Recent content by dulavjo

nurse anesthetist Sent from my iPad using Home Brew

hoping to start a home brew club in Texarkana. please email me for info [email protected] Sent from my iPad using Home Brew

I want to have 5 beers on tap. what size chest freezer will hold five 5 gal kegs

forgot to put the temp probe in the freezer and the beer froze solid. it's under co2 pressure any concerns? should I vent and is the beer no good?

what size hole to drill for 1/2 fittings for my converted beer kegs. I have 1/2 inch fittings for my SS keg and plastic mash tun

what's the best way to ground the two wire heating element

sorry daughter sent note before I could proof read it. I will be using 120vac to power my RIMs system. will the boil,HLT and the power in relays (30A/250vac DPDT 120vac coil) will the relays work ok with 120vac coming into the box instead of 240. also the yellow LEDs lights that are operated...

my setup will 120vac just to run the heating element for my RIMs system. can I still use the DPDt switches with my system. I am wiring it up the same way Kal has done.

just ordered my parts today. still not sure how to wire it up. I don't want to use a toolbox, so what size electrical box do I need. I would like to upgrade to 2 PIDs and an electric timer.

does anyone have photos of the wiring of the rims tube along with the ssr,pid and temp probe. how people have mounted the components and what Gage wire and type of wire for the wiring

wow

wow

can you please list your componates you bought

were you able to check the size holes. I assume you use soft 1/2 inch tubing.

simple. have you built this circle system? at the store looking at the components it does not look like it will fit together. I have been to 6 plumbing stores and there is no 1 inch braid, it comes in 3/4 inch. sorry if this is the wrong thread for this but I thought someone would be helpful if...