Recent content by dmcmillen

BrunDog, I am interested in getting the draw.io source for the 50a system schematic. Also, is there an electrical symbol library for draw.io? I am not having any luck finding one. Thanks. Edit: Oh, I see electrical symbols under more shapes.

Thanks clearwaterbrewer. Looks like a much better alternative to an xlr connector.

What are those blue/black connectors?

Thanks Kent88. Was having one of those days. I did figure it out.

That'd be a long trip from Northern Illinois to south Mississippi for a brewstand. Hope you'd have another reason from coming. I'm not in a hurry as I'm replacing everything. PM here is a Conversation. I'll start a private conversation for us. BTW, this is a great site; every brewer I know...

Ragnavald, wanted to let you know that if we do agree on a price, but can't get it shipped for a reasonable amount that makes sense to you, we don't have to complete the deal. I'm not trying to make money on the shipping.

Well, make me an offer.

Just the stand or the stand with the burners and gas attachments?

PIEZO STARTER (There are 2 for the 3 burners) 175,000 BTU BURNER (One for BK and one for HLT) 150,000 BTU BURNER (for MT) GAS CONNECTION FOR RIG

I’m updating my brewery to an automated all electric 5 gallon system, so I hope someone can make some use of this; it's made a lot of good beer for me. This is a single tier, direct heat, 3 vessel, 2 pump system able to brew 5 or 10 gallon batches and includes the following: (1) Brutus 10...

Is there any reason why I couldn't use a poly-carbonate enclosure instead of steel, primarily to keep the weight down? For the sub or back panel also? It looks like everything is grounded via wire and not thru the case. Looks like a 24x24 steel case is 50 - 60 lbs.

Thanks. Bit of a loaded question. I know the real answer is "it depends". At this point I don't have a feel for how much wiring I'll have based on my design. Want to err on the side of too big rather than too small and cramming wiring in a small space. I like your layout. Lot's of space...

Thanks, I'll check nextdayautomation out. Any suggestions on wire duct? 2x2, 3x3 ??

Anyone have a suggestion for a good source for an enclosure. I've done a lot of searching and for a hinged 24x24x8 without knockouts or gland plate (with or without key) and I'm looking at $200 - $300 (gulp). I would prefer hinged rather than screws.

A dumb question about din rail. It looks like all din rail is 1" wide, but comes in several 'heights'. Someone gave me a piece that is 1/4" high, but as I go to buy some, I see most of it on ebay at 7.5mm high. Does it matter except that what I use should all be the same?