Recent content by Diyhomebrewers

Hi! I know that a few must have been built, but no one tells me that they are using it without problems. Mine in my scenario works correctly but I hardly have any more feedback.

It doesn't do anything, with the pins it only comes in if I cross the pins or restart at the same time. But nothing happens, it also enters the configuration if I leave it at 90 degrees, it is enough for me, I was looking to be able to enter the configuration without opening it thank you

Hello good. I can enter! But do I have to maintain the crossover between both pins and restart from the esp reset button? it's right? Is it not possible without pressing the reset button?

I think not, in a few hours I'll prove it to you since I'm no longer at home and I'll update you. thx

gyroscope: VCC > 33 GND > 25 SCL > 26 SDA > 27 input pin to condig: 13 - 15

Yes, I think it tries but it doesn't like something about how it initializes the gyroscope and it doesn't enter due to the error "GYRO: No valid calibration values, please calibrate the device". From that point: If I flash the floaty firmware, it works then the gyroscope is fine. - If I remove...

Hi! have you been able to review it? thx

In the video the inclination of the floaty is good, I have been using that for years. Have you been able to enter the configuration as gravitymon with pins 13 and 15?

Thx!

I attach the log, if it is helpful, if I press the reset button twice I can return to the gravity mon AP mode and configure the Wi-Fi parameters.

Hello everyone. I'm trying GravityMon again, with the hardware of a floaty, but I can't get into the configuration mode (crossing pins 13 and 15) after flashing it and configuring the Wi-Fi. In principle, I rule out hardware problems since I tested two floaty that are working as the floaty...

Fantastic!

Try it from a PC, mobile phones often tend to disconnect from the network if they don't have a network.

That message is that it does not connect with the configured Wi-Fi, not with the AP (because you will not have it configured yet), as an AP you should connect without any problem. and then access the IP http://192.168.4.1/ to add your WiFi credentials.

What version of PillRepeater are you using?