Recent content by csuf_kmcglynn

BrewSwag 728
Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum

Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. C

    Carboy/ Keg Cleaner Giveaway

    My response :-)
  2. C

    SET620 PID Temp Controller Question

    replaced it with an rtd and had to bend it up cause the detector was too low for the true fluid temp... now just need to do that to the other 2 pots
  3. C

    SET620 PID Temp Controller Question

    the spec sheet covers both their type j and type k thermocouples that they carry, unfortunately I ordered the type k... i assume it is a horrible response time... later today im going to test it out with an actual platinum rtd... hopefully that will work
  4. C

    SET620 PID Temp Controller Question

    unfortunately i do not have any type j thermocouples laying around... as time goes on the temperature difference of actual and pid reading increases... i verified the voltage reading while running with a multimeter and it matched the pid reading... as far as my connections, all are soldered in...
  5. C

    SET620 PID Temp Controller Question

    no one????
  6. C

    red lion controls

    another option is the click plc from automation direct... that is what i am actually using mostly because the software to program it is free
  7. C

    Timer or no Timer???

    i actually using a plc with a couple of internal timers and 1 digtal timer hooked up to 3 pid temp controllers for automation of a HERMS... i need to figure out how to do the hopping though... all the timers need some type of input to start and an alarm signal is sent to the plc for each timer...
  8. C

    SET620 PID Temp Controller Question

    Hello... currently I am working on an automated HERMS system using fleebay SET620 temp controllers, a digital timer, solenoid valves, and a plc for a senior project... my question is regarding the PID temp controller as it appears the temp reading are always incorrect... I am using some type k...
See more
Back
Top