Recent content by Chicoquente

I replaced every seal/oring and used keg lube on the o-rings. As well I replaced the worm clamp with an oetiker clamp. I did in fact buy extras on everything to have on hand. I completely agree these are better to have on hand since they are cheap as opposed to needing them and not having...

Thank you to both of you. I hope to get my supplies in the next week days and ideally do all my fixes this weekend and see where we are at. I appreciate all of your advice.

Thanks guys. I'll make a point of getting those items. Quick question about sizing. From the link to the gas line I purchased it says it uses a 5/16" swivel nut. Am I correct in assuming I require a 5/16" fish eye flare washer? I only ask because I am having a hard time locating one so far near...

@Golddiggie - Thanks. Tonight I will hopefully get a chance to reassemble and test at a higher PSI. Is my previous assumption correct that because there is no indication of liquid leakage anywhere that my issue is between the CO2 Tank and the Sanke coupler? For now I will have no choice but to...

Hi everyone. I am new to the forums and discovered it while trying to figure out the issue with a DIY kegerator I built last month. I was totally new to this and it only came about because we ended up with a mini fridge we no longer needed and since my wife works at a brewery it seemed like a...